Post by rustyau on Jul 8, 2017 6:36:16 GMT 10
Hi all,
Put a valve on the Highbanker so that you can control the water flow (very handy when you are 90m away from your pump). The bottom and top elbows are not glued together so I can swing the bottom inlet to either side of the Highbanker depending on where I have to set up the pump or position the Highbanker and the valve setup can be removed from the top for transport. It is tight enough and it has never blown off.
I made this screen to fit in the screen on the top of the Highbanker when doing clays, roots, grasses etc. This stops the stuff from sliding straight out the end and allows the water time to do its job in difficult ground. It’s a bit wider on the bottom so I have to squeeze it into position and it won’t get pushed out.
Russ
Put a valve on the Highbanker so that you can control the water flow (very handy when you are 90m away from your pump). The bottom and top elbows are not glued together so I can swing the bottom inlet to either side of the Highbanker depending on where I have to set up the pump or position the Highbanker and the valve setup can be removed from the top for transport. It is tight enough and it has never blown off.
I made this screen to fit in the screen on the top of the Highbanker when doing clays, roots, grasses etc. This stops the stuff from sliding straight out the end and allows the water time to do its job in difficult ground. It’s a bit wider on the bottom so I have to squeeze it into position and it won’t get pushed out.
Russ
Attachments:
